Overview of Training Courses

We have packed numerous important simulation options that are available at Simcenter into training courses. When it comes to the scope, we have mostly based ourselves on the respective license packages. Choosing the right training course is certainly not easy for you. So, just give us a call to discuss which training is right for you. The following is a structured list of the training courses we offer. If you select a link, the detailed description appears.

After selecting a link, the detailed training description follows below

3.3 Analysis of Electric Machines with Simcenter NX-Magnetics

This email address is being protected from spambots. You need JavaScript enabled to view it.

Customervoice

Duration

3 days

Description

Based on the training "EM analysis" the analysis of electric motors with MAGNETICS for NX is discussed in this seminar.

Special methods for the creation and automation of the models and the development of templates are explained. Content of this seminar is both the analysis of synchronous as well as asynchronous motors.

By the training the participants will be enabled to analyze and optimize its electric motor models efficiently in terms of torque curves and induced voltages as well as the dissipation.

Prerequisites

- Basic training "EM analysis"

Contents

- Motion models
- Motion in 2D and 3D, translational and rotational
- Enforced and dynamic motions
- Contact 
- Automated preprocessing of motor models
- Templates
- Magnet models, coil models
- Building and analysis of a permanent-magnet synchronous
  motor (PMSM)
- Analysis methods for asynchronous motors
- Automatic definition of the coil scheme
- 1D-networks, star/delta connections
- Determination of the torque curve and induced voltage
- Analyze losses, loss models