Overview of Training Courses

We have packed numerous important simulation options that are available at Simcenter into training courses. When it comes to the scope, we have mostly based ourselves on the respective license packages. Choosing the right training course is certainly not easy for you. So, just give us a call to discuss which training is right for you. The following is a structured list of the training courses we offer. If you select a link, the detailed description appears.

After selecting a link, the detailed training description follows below

5.2 FEM for Designers with NX

This email address is being protected from spambots. You need JavaScript enabled to view it.

Customervoice

Duration

2 days

Description

The usual calculation methods are no longer sufficient for the designer to check component models with complex geometry with regard to mechanical loads. Here, numerical calculation methods (finite element method FEM) must be used.

Continue Reading

7.2 Advanced Meshing

This email address is being protected from spambots. You need JavaScript enabled to view it.

Duration

1 day

Description

High quality elements are the basis for successful finite element analyzes. It is therefore essential to pay particular attention to this part of the simulation process.

Continue Reading

8.1 Update Training

This email address is being protected from spambots. You need JavaScript enabled to view it.

Duration

1-2 days

Description

In this advanced / update seminar, the handling of the Simcenter modules in the current or future version is trained if a version change is pending.

Continue Reading

6.1 SDM with Teamcenter for Simulation

This email address is being protected from spambots. You need JavaScript enabled to view it.

Duration

2 days

Description

This seminar deals with the administration of simulation data in Teamcenter.

Continue Reading

7.3 NX Open Programing and Interfaces to Simcenter

This email address is being protected from spambots. You need JavaScript enabled to view it.

Duration

2 days

Description

In this seminar programming techniques and automation of typical processes around Simcenter 3D / NX CAE are presented.

Continue Reading

7.1 CAD Methods for Simulation Engineers

This email address is being protected from spambots. You need JavaScript enabled to view it.

Duration

3 days

Description

The seminar is intended to give simulation users an introduction to working with Siemens NX and impart the most important methods for preparing the model for simulation.

Continue Reading

7.4 Topology Optimization

This email address is being protected from spambots. You need JavaScript enabled to view it.

Duration

1 day

Description

Driven by high quantities and material costs, components are getting slimmer and lighter. Nevertheless, the strength requirements must be met. Many engineers face this task. One approach is to optimize the topology with Simcenter NASTRAN.

Continue Reading

  • 1
  • 2